About the Trust


Work on the overhaul of 5025 began at the beginning of 2012. This was thanks to grants or promises of support from the Strathspey Railway Company, the Strathspey Railway Trust, the Heritage Lottery Fund the Strathspey Railway Association and the significant amount which had already been raised from our supporters though appeals.

Major progress has been made on the locomotive and tender frames, axleboxes, motion, dragboxes and valve gear at Aviemore and on the major rebuild of the boiler, reprofiling of the tyres of the locomotive and tender wheels and construction of a new tender tank at Riley Engineering of Bury. Work has also included the casting and machining of a pair of new cylinders

The WEC Watkinson Trust originally hoped to return 5025 to service in 2015, however owing to the amount of work needed, a more realistic aim is for completion is towards the middle / end of 2017.

To achieve this further donations to the WEC Watkinson Trust will be welcomed by our treasurer: WAD Macphail CA, ‘Ardneil’, 80 Bruceland Road, Elgin, Moray, IV30 1SP.





Tuesday, 16 May 2017

16th May 2017. A little progress

There has been some progress with the riveting of the front end.  This is despite the other engines constantly demanding attention.
The heating of the rivets has changed from the oven, to using an oxy-acetylene lance.  This method is proving to be quicker in that when a rivet is in the oven, when taken out, it takes a while to heat the oven back up again.


The countersunk rivets that hold the angle iron to the top of the buffer beam.  This angle in turn hold the running plate.


 Looking at the rear of the buffer beam, the angle that was mentioned previously can be seen at the top.  The strengthening flitch plates on this side have also been riveted into place.


The buffer beam with the addition of the vacuum pipe dummy coupling.


And later with the addition of the front buffers themselves.


In between the frames, the front bogie mounting stretcher has been riveted into place.


The rear stretcher under this front section is also now permanently riveted into its place.


The rear of the centre section of the buffer beam.  This shows the left hand flitch plate and centre draw hook strengthener permanently in place.


On the outside of the frames, above where the cylinders will fit, is the running plate support angle which has also been riveted into place.


No comments:

Post a Comment